WALI Articulating TV Monitor Wall Mount

For being one of the cheapest mounts I found, it is quite strong and does everything advertised. It does tilt, it's just not something you can adjust on the fly. Once you set the tilt amount it's a pain to change it. The rest of the installation was fine. I only had a 3/16 drill bit which made it much more difficult. I had to wiggle the drill bit until the hole was big enough for the screws and still had a hard time screwing them into the wall. I would not recommend using a 1/4" bit though, the screws might get loose and the whole thing could fall off. I would also not recommend mounting this on drywall alone. You definitely want to find a wooden stud. Don't take the risk of your TV falling off the wall and taking a chunk of drywall with it! How to set the tilt: in the center of the part of the mount that attaches to the monitor there is a hex nut. Loosen this nut with the tool provided. Now that little nut piece can slide around a little dome on the mount which allows you to adjust the tilting angle. Try to keep it centered vertically (left/right tilt and rotation can all be adjusted afterwards and on the fly). If you move the nut piece up the dome, the monitor will be tilted up and if you put it lower on the dome the monitor will be tilted down. When the angle seems good, tighten the nut back up. I'll try to add a video. The installation of the monitor was actually easier than with another mount I have because you don't have to hold the monitor /TV in place while you screw it into the mount. Just attach the wall arm to the wall and the TV mount to the TV and then you can set them together with an easy little latch and it will stay in place while you add the last screws to keep them secure. I did it all by myself and I'm just an average woman.