Celestron Telescope Carrying Case

This is a great case. Much better than using the box my Nexstar 6se was shipped in. For a while I tried using a rubbermaid bin and reusing the foam packaging, but it was not that convenient to carry around. You couldn't carry it one handed. One side holds your scope. For the 6se you wont need the two foam spacer inserts. To get the 6se to fit, you need to stretch the case foam a bit to clear the visual back and focuser. At first I was concerned about the pressure of such a snug fit, but the foam does give a bit so it is fine. Be aware that the 4/5/6se will fit with the mount attached, but for the 8se you will need to remove the mount. Only the 8se optical tube will fit. The picture on the insert of the case (check out the pictures on the celestron site to see what I mean) shows the OTA placed with the hand control on the right and the bolt that attaches the tube to the fork arm pointing up, however I had to insert it reversed (mirrored) for that to work. In other words, when I place the OTA in the case I have the hand control on the left so the fork arm knob points up. If I placed it as the pamphlet showed, the knob would be pointing down and I think that would prevent it from laying truly flat. I had to remove the finderscope, not to mention the diagonal. The 4/5se might allow room to have them attached, but I wouldn't bet on it. It also has a nice seat belt buckle to secure it. The other side has a slightly rigid zippered flap the size of the entire side. It is recessed so as to have enough clearance when the case is closed. Unzipping the flap and lifting it up reveals it has a full length pocket on the other side. You could possibly fit notes and small starcharts within it. I place my eyepiece tray in it even though part of it sticks out. No worries since when the flap is zipped everything inside is separated from the OTA. Underneath where the flap lays, there are two velcro closed pouches. Inside one pouch there are three separated spaces. The other pouch has four. In one pouch, I could easily fit the finderscope, the diagonal, and AC power cord. The other pouch will accommodate eyepieces, filters and other odds and ends.The pouches themselves feel slightly padded as well. The handles include a velcro wrap to make sure the straps stay together. The outer shell is a bit rigid, but I would not go about dropping or banging it around. Don't expect to step on it and not crunch something inside. It is a vessel to store your OTA and accessories elegantly and convenient to carry around one handed. While the case itself looks like it would withstand normal wear and tear, I wouldn't want to cause any damage to it that would affect the contents inside. Do yourself a favor and get this case. While it is hard to justify the cost of this as opposed to a DIY solution. This is designed for your scope and it is worth it in my opinion.