Pyle PLAM3601D 3600W Class D Monoblock Power Amplifier

New
Limit 3 per customer
add to cart

Features

Protect Your Stuff
2-year protection plan: $11.99 Buy Now

Versatile Hybrid Amplifiers
The Pyle Academy Series Amplifiers will provide your audio setup with sophisticated new sound and serious power. Add performance and quality enhancement to your music when you upgrade your audio system with these rugged and high-efficiency amps. Enjoy tomorrow’s advanced sound technology that outperforms all other amps in its class.

Sound Specialization
These high-efficiency class-D amplifiers host an impressive power output and are where form and function meet. Configurable for Bridgeable and Tri-Way applications, built-in Variable Subwoofer Crossovers, MOSFET Pulse Width Modulated Power Supply, High Level Low Impedance MOLEX Input Connector, strong frequency response rates along with plenty of more features that make the Pyle Academy Series Amplifiers smarter than the competition.

Intelligent Design
Safety features include power and protection LED indicators; soft turn-on/off, thermal, overload and speaker-short protection. The built-in air-induction fan cooling system acts as another line of safety keeping you and your equipment safe. Status LED Diagnostic Condition indicators show when the amplifier is powered up normally and when your system is experiencing a protection fault.

Pump it Up
Take advantage of the Bass EQ Boost to add massive quality sound and performance. Make adjustments to the Bass EQ settings until you achieve that extra amount of kick you’ve been waiting for.

Intelligent Sound – Intelligent Style
The smooth-edged and rounded design leaves a blue-pearl gloss finish on the fortified aluminum heat-sink. The stream-lined and high-tech appearance will definitely add some attention to your audio.

Total Audio Control
Once you are connected, customize and adjust your listening experience to your liking with the amplifier’s control center. You can personalize and fine-tune settings like:

  • High-Pass Filter – When Crossover Mode is in High-Pass Mode, this control limits the frequencies which will be distributed to the speakers Crossover Switch – Routes output of the Low Pass (LP), or the output of the High Pass (HP) filters, or ‘FULL’ to the internal power amplifier.
  • Low-Pass Filter - When Crossover Mode Selector is in Low-Pass Mode, this control limits the frequencies which will be distributed to the speakers.
  • Line Input – Accepts line level (RCA) inputs from 0.2 to 5-Volt.
  • High-in - Accepts speaker level inputs from radios that do not line level (RCA) outputs.
  • Bass EQ - Gives you manual control over Bass Boost decibel adjustments.

Input Connections
Turn the volume control on the amplifier to minimum initially. Once the initial power sequence has been performed, set the volume control to roughly 80% of full power. Play some audio and slowly turn up the amplifier volume control until you hear some distortion, and then back it off for the sharpest sound setting. This amplifier has RCA connections for Low Level inputs. Low Level signal is carried through RCA cables. It is preferred to use Low Level inputs to the amplifier if the headunit is equipped with matching outputs.

Speaker Output Connections
Connect right and left speaker wire to corresponding speaker output terminals of the terminals. Be sure to have the positive wire from the speaker to the positive speaker terminal of the amplifier and the negative wire from the speaker must connect with the speaker terminal of the amplifier. Reversing any of these connections will result in the speaker cones moving out of phase which causes bass cancellation.


Shipping Note: Shipping to Alaska and Hawaii is not available for this item

A physical address is required for delivery. No Military or PO Box shipments available

Warranty: 1 Year Pyle

Specs

  • Class D Monoblock Power Amplifier
  • RMS Power @ 4 Ohms: 1x1000 W
  • RMS Power @ 2 Ohms: 1x1500 W
  • RMS Power @ 1.3 Ohms: 1x2000 W
  • Maximum Power Output 3600W Mono
  • Mono Block Sub woofer Amplifier
  • Frequency Response 15 Hz-150 Hz (±3dB)
  • Output Power @ 14.4v DC, 50Hz
  • 1 Ohm Stable
  • MOSFET Power Supply
  • PWM ( Pulse-Width-Modulation ) System
  • Glass Epoxy PCB
  • Silver RCA Inputs
  • Custom Terminal Block for Speaker Connection
  • Thermal / Overload / Short Circuit Protection
  • Variable Subsonic Filter ( 15Hz - 55Hz 24dB / Octave)
  • Remote Bass Boost
  • Input Impedance: 10K Ohms
  • Soft Turn On/ Off
  • Advanced Protection Circuitry
  • S/N Ratio: >90dB
  • Dimensions: 9.76''W x 2.28''H x 13.78''L
  • Weight: 10.1 lbs.

In the box:

  • Pyle PLAM3601D 3600W Class D Monoblock Power Amplifier

Sales Stats

Speed to First Woot:
8h 49m 37.338s
First Sucker:
wootmiester2
Last Wooter to Woot:
spiderbbb

Purchaser Experience

  • 22% first woot
  • 0% second woot
  • 22% < 10 woots
  • 11% < 25 woots
  • 44% ≥ 25 woots

Purchaser Seniority

  • 11% joined today
  • 0% one week old
  • 11% one month old
  • 11% one year old
  • 67% > one year old

Quantity Breakdown

  • 89% bought 1
  • 11% bought 2
  • 0% bought 3

Percentage of Sales Per Hour

11%
0%
0%
0%
0%
0%
0%
0%
11%
0%
0%
0%
0%
0%
22%
0%
11%
11%
0%
0%
22%
0%
0%
11%
12 1 2 3 4 5 6 7 8 9 10 11 12 1 2 3 4 5 6 7 8 9 10 11

Percentage of Sales Per Day

33%
0%
33%
22%
0%
11%
0%
Mon Tue Wed Thu Fri Sat Sun

Woots by State

zero wooters wootinglots of wooters wooting
3600W Class D Monoblock Power Amplifier
$89.99 Sold Out Electronics
$89.99 USD false 1 Retail EA
1 3
Woot! Electronics.Woot
4121 International Pkwy Carollton TX 75007 U.S.A.